Professional AC Installation
at Your Doorstep.
Expert dual-unit indoor and outdoor split AC installation with laser spirit leveling, core hole drilling, vacuum leak purging, and electrical load balancing.
Supported AC Systems & Configurations
Standardized mounting protocols tailored to tonnage, indoor architectural limits, and exterior balcony or parapet constraints.
Split AC Installation
0.8T – 2.5 TonInverter and regular dual-unit installations with wall plate laser alignment, vibration damper rubber pads, and clean drain slants.
- check Indoor high-tensile wall bracket anchoring
- check Precision brass flare nut torquing
- check Outdoor condenser isolator vibration pads
Window AC Installation
1.0T – 2.0 TonComplete chassis unboxing, sill leveling, heavy iron perimeter frame support, and airtight foam insulation around the casing.
- check Wooden/aluminum frame leveling & wedge anchoring
- check Thermal perimeter weather-strip sealing
- check Gravitational back-tilt for condensate drainage
Cassette & Multi-Split
Commercial / VillaSuspended ceiling grid installation, multi-point manifold flare links, and synchronized outdoor inverter branch controllers.
- check Soffit ceiling rod suspension & vibration dampers
- check Multi-point drain pump routing & U-trap testing
- check Nitrogen pressure holding test prior to commissioning
Our 5-Step Precision Mounting Protocol
Every installation follows strict manufacturer guidelines to preserve factory warranty and optimize energy consumption.
Site & Laser Alignment
Locating wall rebar, inspecting studs, and setting a 2° gravitational drain tilt to prevent indoor condensation dripping.
Core Hole & Anchoring
Industrial diamond core drill with vacuum bag to minimize dust. Heavy expansion anchor bolts secure the bracket.
Flare & Wiring Joint
Eccentric cone flaring for mirror-smooth gas seals. High-grade 3-core communication line terminated with crimp lugs.
Two-Stage Vacuum
Deep micron vacuuming (500 microns) eliminates air and moisture before any valve release, ensuring maximum cooling efficiency.
Delta-T Commissioning
Service valve opening, current draw measurement (Amps), and thermal anemometer verification of cold air supply.
Standard Installation & Add-on Rate Card
No hidden surprise charges. You only pay for the installation labor upfront. If your layout requires extra copper piping, electrical cables, or brackets beyond what came in your AC carton, charges follow these standard regulated prices.
- • Unboxing and mounting indoor wall backplate
- • Drilling single standard brick/plaster core hole (up to 3.5 inch)
- • Fitting manufacturer-supplied copper pipe (up to 3 meters)
- • Two-stage vacuum pump purging and flare nut tightening
- • Operational performance and temperature drop check
Before the Technician Arrives
To ensure a seamless 90-minute installation without delays, please verify these three prerequisite checklist items at your premises.
16A Power Socket
Dedicated 16 Amp three-pin wall socket with MCB within 1 meter of the indoor mounting location.
Outdoor Access
Accessible balcony, dry terrace ledge, or safe exterior wall clearance for outdoor condenser installation.
Society Clearance
Pre-approval from residential society or building manager for standard core drilling on exterior facades.
Frequently Asked Questions
Everything you need to know about AC installation bookings, tools, and warranties.
Frequently Paired Services
Safe Pump-down
AC Uninstallation
Safe refrigerant pump-down into compressor, non-destructive pipe uncoupling, and demounting of indoor & outdoor brackets.
Deep Chemical Foam
Foam-Jet AC Deep Clean
High-pressure power jet washer clean with antibacterial foam that extracts 99% embedded dust and mold from inner blower coils.
32-Point Check
AC Repair & Diagnostics
Full diagnostic testing for cooling failure, PCB motherboard errors, fan motor noise, and refrigerant gas level analysis.
Ready to Install Your New AC?
Get certified HVAC technicians equipped with laser levels, core drill shrouds, and micron vacuum pumps at your doorstep Next Available Slotutes.